Gaining Access to Memory Modules
Figure B-8
1 DIMM
2 Connector fingers
Installing the Network Expansion Module (NEM)
Refer to Figure
1.
Position the network expansion module so its front panel is under the edge of the
DFE module front panel.
2.
Align the two network expansion module connectors with the main board connectors.
Then press straight down over the two network expansion module connectors,
applying pressure until they are properly seated.
B-12 Mode Switch Settings and Option Installations
Installing the DIMM
Â
B‐9 and proceed as follows:
Ã
À
Á
Â
3 Connector arms
4 Alignment notches (2)
Ã