Unpacking The Module; Installing Optional Flash Upgrade; Installing The Module Into The Matrix E7 Chassis; Contents Of Module Carton - Enterasys 6H302-48 User Manual

Unpacking the Module

3.1 UNPACKING THE MODULE
Unpack the module as follows:
1. Open the box and remove the packing material protecting the module.
2. Verify the contents of the carton as listed in
Table 3-1 Contents of Module Carton
Item
One module, either the 6H302-48 or the 6H303-48
Antistatic Wrist Strap
Manual Accessory Kit
3. Remove the tape seal on the non-conductive bag to remove the module.
4. Perform a visual inspection of the module for any signs of physical damage. Contact Enterasys
Networks if there are any signs of damage. Refer to
3.2

INSTALLING OPTIONAL FLASH UPGRADE

NOTE: Install any optional equipment before proceeding to
If the module is to be installed with an optional FLASH upgrade, refer to
installation instructions.
3.3

INSTALLING THE MODULE INTO THE MATRIX E7 CHASSIS

CAUTION: Failure to observe static safety precautions could cause damage to the
module. Follow static safety handling rules and wear the antistatic wrist strap provided
with the Matrix E7 chassis.
Do not cut the non-conductive bag to remove the module. Sharp objects contacting the
board or components can cause damage.
The module can be installed in any of the slots that are available.
3-2 Installation
Table 3-1.
Quantity
1
1
1
"Getting Help" for details.
Section 3.3.
Appendix B for complete