Removing the DIMM
To remove the DIMM, refer to Figure
1.
Refer to Figure
the connector.
Note: The ejector arms on this connector are not spring-loaded, so they will remain in the
open position until manually closed.
2.
Remove the DIMM from the connector.
Figure B-5
Removing the Existing DIMM
1 Connector arms
Installing the DIMM
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
To install the DIMM, refer to Figure
1.
With the connector arms set in the open position, insert the DIMM between the
connector fingers and push the DIMM into the connector until the tabs on the two
connector arms pull in towards the DIMM alignment notches.
2.
Push the DIMM further into the connector until the two DIMM alignment notches
and the tabs on the two connector arms lock the DIMM into place.
3.
Reinstall the network expansion module. Refer to "Installing the Network Expansion
Module (NEM)" on page B‐12 for instructions.
B‐5 and proceed as follows.
B‐5. Push the connector arms away from the DIMM to release it from
À
Â
2 Memory module
B‐6 and proceed as follows:
Gaining Access to Memory Modules
Á
À
3
Connector
DFE-Platinum Series Hardware Installation Guide B-9