Chapter 4: Troubleshooting; Using Lanview; About The Management (Mgmt) Led; Troubleshooting Checklist - Enterasys Platinum Distributed Forwarding Engine 7G4205-72 Hardware Installation Manual

Dfe-platinum series

Hide thumbs Also See for Enterasys Platinum Distributed Forwarding Engine 7G4205-72:

Table of Contents

This chapter provides information concerning the following:

For information about...

Overview of DFE Module Shutdown Procedure

Recommended Shutdown Procedure Using OFFLINE/RESET Switch

Last Resort Shutdown Procedure Using OFFLINE/RESET Switch

Using LANVIEW

The DFE module uses a built‐in visual diagnostic and status monitoring system called

LANVIEW. The LANVIEW LEDs (Figure

status to aid in diagnosing network problems.

The MGMT LED (shown in Figure

Management Module to control the management functions for all DFE modules in the

chassis. The Management Module handles all IP requests to the chassis IP address, such

as, but not limited to, PING, Telnet, SNMP, HTTP. The Management Module also handles

the CLI configuration sessions through the console port. So, when you plug into a DFE

module COM port to configure a DFE module in the chassis, it is handled by the

Management Module regardless of the DFE module COM port that you use.

Troubleshooting

4‐1) allow quick observation of the network

4‐1) indicates when the module is serving as the

DFE-Platinum Series Hardware Installation Guide 4-1

Refer to page...

4-1

4-8

4-10

4-11

4-12

Table of Contents

Troubleshooting

Dfe-platinum 7g4285-49 Dfe-platinum 7g4205-72