Safety Information; Declaration Of Conformity - Enterasys Platinum Distributed Forwarding Engine 7G4205-72 Hardware Installation Manual

Dfe-platinum series

Hide thumbs Also See for Enterasys Platinum Distributed Forwarding Engine 7G4205-72:

Specifications (5 pages)

Table Of Contents

Table of Contents

Read the following safety information before installing or operating these modules.

The Class 1 laser transceivers use an optical feedback loop to maintain Class 1 operation limits. This control loop

eliminates the need for maintenance checks or adjustments. The output is factory set, and does not allow any user

adjustment. Class 1 Laser transceivers comply with the following safety standards:

• 21 CFR 1040.10 and 1040.11 U.S. Department of Health and Human Services (FDA).

• IEC Publication 825 (International Electrotechnical Commission).

• CENELEC EN 60825 (European Committee for Electrotechnical Standardization).

When operating within their performance limitations, laser transceiver output meets the Class 1 accessible emission

limit of all three standards. Class 1 levels of laser radiation are not considered hazardous.

When the connector is in place, all laser radiation remains within the fiber. The maximum amount of radiant power

exiting the fiber (under normal conditions) is ‐12.6 dBm or 55 x 10

Removing the optical connector from the transceiver allows laser radiation to emit directly from the optical port. The

maximum radiance from the optical port (under worst case conditions) is 0.8 W cm

Do not use optical instruments to view the laser output. The use of optical instruments to view laser output

increases eye hazard. When viewing the output optical port, power must be removed from the network adapter.

Application of Council Directive(s): 2004/108/EC

European Representative Address: Enterasys Networks, Ltd.

Conformance to Directive(s)/Product Standards: EC Directive 2004/108/EC

Enterasys Networks, Inc. declares that the equipment packaged with this notice conforms to the above directives.

Class 1 Laser Transceivers

The single mode interface modules use Class 1 laser transceivers.

Declaration of Conformity

Manufacturer's Name: Enterasys Networks, Inc.

Manufacturer's Address: 50 Minuteman Road

Equipment Type/Environment: Networking Equipment, for use in a Commercial