Enterasys Platinum Distributed Forwarding Engine 7G4205-72 Hardware Installation Manual page 64

Using LANVIEW
Table 4-1 LANVIEW LEDs (continued)
LED
RX/TX Indications in Standard Mode
RX
(Receive)
TX
(Transmit)
4-6 Troubleshooting
Color State
Off No link. No activity. Port
enabled or disabled.
Green Solid. Link present, port
enabled, no traffic is being
received by the interface.
Amber Flashing. Link present, port
enabled, traffic is being
received by the interface.
Red Blinking. Indicates
collisions. This indication is
only supported on 10/100
ports.
Off Port enabled, but no activity.
Green Flashing. Indicates data
transmission activity. Rate of
flashing indicates the data
rate.
Red Flashing. Fault or Error
(collision).
Recommended Action
None.
None.
None.
Contact Enterasys Networks for
technical support.
If it is known that the port should be
active and is not, contact
Enterasys Networks for technical
support.
None.
None, unless there is a high rate of
activity. In this case, check for network
configuration problems or a defective
device.