Remote Fax Commands - Brother MFC-665CW User Manual

Chapter 10
Remote Fax commands
Follow the commands below to access features when you are away from the machine. When you
call the machine and enter your remote access code (3 digits followed by -X-),the system will give
two short beeps and you must enter a remote command.
!i!i ....
91 Playing Voice messages After one long beep, the machine plays the ICM.
(MFC-665CW only)
1 Repeat or Skip Backward Press 1 while listening to an ICM to repeat it. If you press 1
before a message, you will hear the previous message.
2 Skip Forward While playing the ICM, you can skip to the next message.
9 STOP Playing Stop Playing the ICM.
93 Erase all ICM If you hear one long beep, the erase is accepted. If you hear
(MFC-665CW only) three short beeps, you cannot erase because all voice
messages have not been played, or there are no voice
message to erase.
*This code erases all recorded messages, not one at a time.
94
1 Play
2 Record
Play and Record OGM in Memory
(MFC-665CW only)
1 Msg Ctr OGM
2 F/T OGM
1 Msg Ctr OGM
2 F/T OGM
95 Change the Fax Forwarding,
Paging or Fax Storage settings
1 OFF
2 Fax Forwarding
3 Paging
4 Fax Forwarding number
6 Fax Storage
The machine plays the selected OGM. You can stop playing
OGMs by pressing 9.
After one long beep, you can record the selected OGM. You
will hear the message played once. You can stop recording
the message by pressing 9.
You can choose off after you have retrieved or erased all
your messages.
One long beep means the change is accepted. If you hear
three short beeps, you cannot change because something
has not been set up (for example, a Fax Forwarding or
Paging number has not been registered). You can register
your Fax Forwarding number by entering 4. (See Changing
your Fax Forwarding number on page 86.) Once you have
registered the number, Fax Forwarding will work.
96 Retrieve a fax
2 Retrieve all faxes Enter the number of a remote fax machine to receive stored
fax messages. (See Retrieving fax messages on page 86.)
3 Erase faxes from the memory If you hear one long beep, fax messages have been erased
from the memory.
97 Check the receiving status
(MFC-440CN only)
1 Fax You can check whether your machine has received any
faxes, if yes, you will hear one long beep. If no, you will hear
three short beeps.
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii! ! 84