Table of Contents
Advertisement
Setting the User 1/User 2 mode
There are two user-definable modes if the current available picture modes are not suitable for your need.
You can use one of the picture modes (except the selected User mode) as a starting point and customize
the settings.
1. In the Picture -- Basic menu, highlight Picture Mode and press
mode.
2. Press
to highlight Load Settings From.
This function is only available when User 1 or User 2 mode is selected up in the Picture Mode sub-
menu item.
3. Press ENTER to display the Load Settings From page.
4. Press
to highlight a picture mode that is closest to your need and press ENTER and EXIT.
5. Press
to select a sub-menu item to be changed and adjust the value with
the picture quality" on page 29
6. When all settings have been done, press MENU on the projector or MENU/EXIT on the remote
control to save and leave the settings.
Renaming user modes
You can change User 1 and User 2 to the names easy to be identified or understood by the users of this
projector. The new name can be up to 12 characters including English letters (A-Z, a-z), digits (0-9), and
space (_).
To rename user modes:
1. In the Picture -- Basic menu, highlight Rename User Mode and press ENTER to display the
Rename User Mode page.
2. Press
/
to highlight the item you want to rename and press ENTER. The first letter will be
highlighted by a white box.
3. Press
/
to select the first character.
4. Press
to move along until the new name is set and press ENTER to confirm.
5. Repeat steps 2-4 if you want to change the other names.
Resetting the picture mode
All of the adjustments you've done in the Picture -- Basic and Picture -- Advanced menus can be
returned to the factory preset values with a key press on the highlight of Reset.
To reset the picture mode to the preset factory values:
1. In the Picture -- Basic menu, highlight Picture Mode and press
(including User 1 or User 2) you want to reset.
2. Press
to highlight Reset Picture Settings and press ENTER. The confirmation message is
displayed.
3. Press
/
to highlight Reset and press ENTER. The picture mode will return to the factory
preset settings.
4. Repeat steps 1-3 if you want to reset other picture modes.
Do not to be confused with the Reset Picture Settings function here with the Reset All Settings in the
Advanced Setup menu. The Reset All Settings function returns most of the settings to the factory preset
values system wide. See
28
Using the projector
and
"Advanced picture quality controls" on page 30
"Reset All Settings" on page 49
/
to select User 1 or User 2
/
to select the picture mode
for details.
/ . See
"Fine-tuning
for details.
Advertisement
Table of Contents
