Related Manuals for BenQ DX819ST
Summary of Contents for BenQ DX819ST
- Page 1 BenQ RS232 Commands...
- Page 2 Table of Content 1. RS232 Cable Requirement and Pin Assignment ............. 2 2. RS232 Connection ......................2 3. Interface Settings ......................3 4. Command Table ....................... 3...
-
Page 3: Rs232 Connection
1. RS232 Cable Requirement and Pin Assignment Cable Requirement: RS232 pin assignment Description Description 2. RS232 Connection Notes: Make sure that both of the PC and the projector are turned off before connecting them. Must turn on the PC before turning on the projector. (Wrong step may have Com port working incorrectly) PLS choose appropriate adapter for PC side. -
Page 4: Command Table
2. Interface Settings - RS-232 protocol Baud Rate Default in 115200 bps, but changeable in OSD menu. (2400/4800/9600/14400/19200/38400/57600/115200) Data Length 8 bit Parity Check None Stop Bit 1 bit Flow Control None 3. Command Table Note: The available features are different by model. (eg. source, audio settings, aspect ratio..etc.), please refer to the user manual for the further information. - Page 5 Read Volume Status *vol=?# Write Mic. Volume + *micvol=+# Write Mic. Volume - *micvol= -# Read Mic. Volume Status *micvol=?# Write Audio pass Through off *audiosour=off# Write Audio-Computer1 *audiosour=RGB# Write Audio-Computer2 *audiosour=RGB2# Audio source Write Audio-Video/S-Video * audiosour=vid# select Write Audio-Component * audiosour=ypbr# Write...
- Page 6 Color *ct=warmer# Write Temperature-Warmer Write Color *ct=warm# Temperature-Warm Write Color *ct=normal# Temperature-Normal Write Color Temperature-Cool *ct=cool# Write *ct=cooler# Color Temperature-Cooler Read *ct=?# Color Temperature Status Write Aspect 4:3 *asp=4:3# Write Aspect 16:9 *asp=16:9# Write Aspect 16:10 *asp=16:10# Write Aspect Auto *asp=AUTO# Write Aspect Real...
- Page 7 Write Direct Power On-on *directpower=on# Write Direct Power On-off *directpower=off# Read Direct Power On-Status *directpower= ?# Write Signal Power On-on *autopower=on# Write Signal Power On-off *autopower=off# Read Signal Power On-Status *autopower=?# Write Standby *standbynet=on# Settings-Network on Write Standby *standbynet=off# Settings-Network off Read Standby *standbynet=?#...
- Page 8 Write Eco mode *lampm=eco# Write Smart Eco mode *lampm=seco# Write Dual Brightest *lampm =dualbr# (for dual lamp only) Write Dual Reliable *lampm =dualre# (for dual lamp only) Write Single Alternative *lampm =single# (for dual lamp only) Write Single Alternative Eco * lampm =singleeco# (for dual lamp only) Read...
- Page 9 Write Instant On-off *ins=off# Read Instant On Status *ins=?# Write Lamp Saver Mode-on *lpsaver=on# Write Lamp Saver Mode-off *lpsaver=off# Read Lamp Saver Mode Status *lpsaver=?# Projection Log In Code *prjlogincode=on# Write Projection Log In Code *prjlogincode=off# Write Projection Log In Code *prjlogincode=?# Read Status...