Table of Contents
Advertisement
Entering the password recall procedure
1. Make sure the Input Password page is displayed on screen. Press
and hold PRESET MODE on the projector or MODE/ENTER on
the remote control for 3 seconds. The projector will display a coded
number on the screen.
2. Write down the number and turn off your projector.
3. Seek help from the local BenQ service center to decode the number.
You may be required to provide proof of purchase documentation to
verify that you are an authorized user of the projector.
Changing the password
1. Press MENU on the projector or MENU/EXIT on the remote control and then press
the Advanced Setup menu is highlighted.
2. Press
/
to highlight Password and press ENTER. The Password page is displayed.
3. Highlight Change Password and press ENTER. The Input Current Password page is displayed.
4. Enter the old password.
•
If the password is correct, the message "Input New Password" is displayed.
•
If the password is incorrect, the password error message is displayed lasting for three seconds,
and the message "Input Current Password" is displayed for your retry. You can either press
MENU on the projector or MENU/EXIT on the remote control to cancel the change or try
another password.
5. Enter a new password.
IMPORTANT: The digits being input will be displayed as asterisks on-screen. Write your selected
password down here in this manual in advance or right after the password is entered so that it is available
to you should you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
6. Confirm the new password by re-entering the new password.
7. You have successfully assigned a new password to the projector. Remember to enter the new
password next time the projector is started.
8. To leave the OSD menu, press MENU on the projector or MENU/EXIT on the remote control.
Disabling the password function
To disable password protection, go back to the Advanced Setup > Password > Password menu.
Highlight Password and select Off by pressing
Enter the current password.
•
If the password is correct, the OSD menu returns to the Password page with "Off" shown in
the row of Password. You will not have to enter the password next time when turning on the
projector.
•
If the password is incorrect, the password error message is displayed lasting for three seconds,
and the message "Input Password" is displayed for your retry. You can either press MENU on
the projector or MENU/EXIT on the remote control to cancel the change or try another
password.
Note that though the password function is disabled, you need to keep the old password in hand should
you ever need to re-activate the password function by entering the old password.
24
Using the projector
/
. The message "Input Password" is displayed.
Recall Password
Please write down the recall code,
and contact your nearest BenQ
Customer Center.
0 2 1 2
Recall code:
EXIT
Back
/
until
Advertisement
Table of Contents
