Table of Contents
Advertisement
Selecting an input source
The projector can be connected to multiple equipment at the same
time. When the projector is first turned on, it will attempt to
reconnect with the input source which was in use when the
projector was last shut down.
To select the video source:
•
Using the remote control or projector
Press one of the Source keys on the remote control, or press
SOURCE on the projector repeatedly until your desired signal is
selected.
•
Using the OSD menu
1. Press MENU on the projector or MENU/EXIT on the remote
control, and then press
highlighted.
2. Press
to highlight Input Source and press ENTER. The
source selection bar is displayed.
3. Press
/
repeatedly until your desired signal is selected and
press ENTER.
Once detected, the selected source information will be displayed
on the screen for seconds. If there are multiple pieces of
equipment connected to the projector, you can go back to the
source selection bar again to search for other signals.
•
If you want the projector to automatically search for the signals,
select On in the System Setup > Auto Source Search menu.
•
If you want to use the PIP function, see
page 40
for details.
Changing Color Space
In the unlikely event that you connect the projector to a DVD player via the projector's HDMI input and
the projected picture displays wrong colors, please change the color space to YUV.
1. Press MENU/EXIT and then press
2. Press
to highlight Color Space Conversion and press
This function is only available when the HDMI input port is in use.
/
until the System Setup menu is
"Displaying more than one image source simultaneously" on
/
until the Display menu is highlighted.
NOTE: When
HDMI 1
automatically
searching for a valid
HDMI 2
input source, the
Video
projector cycles
through the available
Component 1
signals following the
Component 2
sequence from top to
bottom as the source
Computer 1
selection bar shows.
Computer 2
/
to select a suitable color space.
Using the projector
21
Advertisement
Table of Contents
