Table of Contents
Advertisement
Color Management
In most installation situations, color management will not be necessary, such as in classroom, meeting
room, or lounge room situations where lights remain on, or where building external windows allow
daylight into the room.
Only in permanent installations with controlled lighting levels such as boardrooms, lecture theaters, or
home theaters, should color management be considered. Color management provides fine color control
adjustment to allow for more accurate color reproduction, should you require it.
Proper color management can only be achieved under controlled and reproducible viewing conditions.
You will need to use a colorimeter (color light meter), and provide a set of suitable source images to
measure color reproduction. These tools are not provided with the projector, however, your projector
supplier should be able to provide you with suitable guidance, or even an experienced professional
installer.
The Color Management provides six sets (RGBCMY) of colors to be adjusted to favorite colors.
When you select each color, you can independently adjust its color range and saturation according to
your preference.
To adjust and store the settings:
1. In the Picture -- Advanced menu, highlight Color Management and press ENTER. The Color
Management page is displayed.
2. Highlight Primary Color and press
Cyan, Blue, and Magenta.
3. Press
to highlight Range and press
you wish to make adjustment. The bigger the range, the more
proportions of its two adjacent colors the color contains.
Please refer to the illustration to the right for how the colors relate
to each other. For example, if you select Red and set its range at 0,
only pure red is selected. Increasing its range will include both the red
color close to yellow and red color close to magenta.
Press
to highlight Saturation and adjust the color saturation level
by pressing
/
If you select Red and set its range at 0, only the saturation of the
pure red will be affected.
Saturation is the amount of that color in a video picture. Lower settings produce less saturated
colors; a setting of "0" removes that color from the image entirely. If the saturation is too high, that
color will be overpowering and unrealistic.
4. To leave and save the settings, press MENU on the projector or MENU/EXIT on the remote
control.
Setting Film Mode
This feature helps improve picture quality when projecting video image from a film-sourced DVD.
32
Using the projector
/
/
.
to select a color from among Red, Yellow, Green,
to select the color range
Yellow
Green
Red
Cyan
Magenta
Blue
Advertisement
Table of Contents
