Table of Contents
Advertisement
Controlling the projector through a Lan
environment
allow you to manage the projector from a computer using a web browser when the
Lan Control Settings
computer and the projector are properly connected to the same local area network.
Configuring the Lan Control Settings
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the other end
to the RJ45 port.
2. Press MENU on the projector or MENU/EXIT on the remote control and then press
the Advanced Setup menu is highlighted.
3. Press
to highlight Lan Control Settings and press ENTER. The Lan Control Settings page is
displayed.
4. Press
to highlight Control By and press
5. Press
to highlight DHCP and press
6. Press
to highlight Apply and press ENTER.
7. Please wait for around 15 - 20 seconds, and then re-enter the Lan Control Settings page.
8. The
Projector IP Address
displayed. Note down the IP address displayed in the Projector IP Address row.
If the Projector IP Address still does not display, contact your ITS administrator.
If you are in a non-DHCP environment:
1. Repeat steps 1-4 above.
2. Press
to highlight DHCP and press
3. Contact your ITS administrator for information on the Projector IP Address, Subnet Mask,
Default Gateway, and DNS Server settings.
4. Press
to select the item you want to modify and press ENTER.
5. Press
/
to move the cursor and then press
6. To save the setting, press ENTER. If you do not want to save the setting, press MENU/EXIT on the
remote control or EXIT on the projector.
7. Press
to highlight Apply and press ENTER.
Controlling the projector remotely through a web browser
Once you have the correct IP address for the projector and the projector is on or in standby mode, you
can use any computer that is on the same local area network to control the projector.
1. Enter the address of the projector in the address bar of your browser and click Go.
/
/
to select On.
,
, Default Gateway, and DNS Server settings will be
Subnet Mask
/
to select Off.
to select RJ45.
/
to enter the value.
/
until
37
Using the projector
Advertisement
Table of Contents
