Settings Menu - Epson STYLUS Scan 2500 Service Manual

EPSON Stylus Scan 2500
SCANNER INITIALIZATION
There are three initialization methods.
1. Hardware initialization
The scanner initializes when turned on.
When the scanner initializes, the following actions are performed.
Initialize scanner mechanism
Clear input/output data buffer
Set default values
2. Operator initialization
The scanner initializes when it recognizes the -INIT signal (negative pulse)
from the parallel interface.
When the scanner initializes, the following actions are performed.
Clear input/output data buffer
Set default values
3. Software initialization
The ESC@ command also initializes the scanner.
When the scanner initializes, the following actions are performed.
Clear input/output data buffer
Set default values
Product Description

1.7 Settings Menu

Enter the settings menu mode by holding down the Quality and B&W/Color
buttons. Settings are saved when the power is turned off.
Button Function
Quality
Change modes
B&W/
Copy<-> Settings Menu
Color
Copies
Change menu in
Settings Menu mode
+/-
Executes menu or
Copy
selects item
Settings Menu
Table 1-16. Settings Menu
LCD
Hold Quality + B&W buttons for three
seconds
Menu Mode
After two seconds
BottomMargin:14/3mm
Cycles through the menus below:
BottomMargin:14/3mm
PaperSize:Metric/US
Lang:Eng Ger Fr Ital Span Port
Set Factory Default
Status Sheet Print
Lang: Eng Ger Fr Ital Span Port
Press copy to change to next
Lang: Ger Fr Ital Span Port Eng
Revision A
28