Epson STYLUS Scan 2500 Service Manual page 98

EPSON Stylus Scan 2500
Step 6.
Remove
the FFC
and FFC
guide.
Step 9. Remove
the printhead.
Printhead Unit
Note: There are no
actuators on the printhead.
Figure 4-3. Removing the Print Head
Disassembly & Assembly
Fastener Head
Step 8.
Remove
one CBP
3x6 screw
and the
FFC
fastener.
Step 7.
Remove the
tension spring
located here.
Disassembling the Printer Mechanism
Make sure that
this protrusion is
in the U ditch of
the print head
side.
Nozzle Selector has been enclosed into head.
Figure 4-4. Installing the Printhead
Revision A
This part should
be touching the
CR shaft receiver.
Make sure that
the protrusion of
the carriage fits
in this hole.
Carriage Assembly
97