Epson STYLUS Scan 2500 Service Manual page 104

EPSON Stylus Scan 2500
4.6.4.2 Removing the Right and Left LD Roller Assembly
1. Disassemble the ASF assembly and remove the paper feed roller
assembly and hopper assembly from the ASF assembly. (Refer to Section
4.6.4.)
2. Take out the right and left compression springs 1.66 from the back of the
hopper assembly.
3. Pull out the cam part of the hopper assembly from the hole located on the
frame of the right LD roller assembly,
4. Pull out the LD roller shaft. The paper feed roller assembly and hopper
assembly should be disconnected by now.
5. Release the hook of LD roller assembly at the shaft hole of the paper feed
roller assembly. Also, release the fixed hook of the cover roller LD and
remove the LD roller assembly.
When installing the LD roller assembly, make sure
T
that the hooks are hung on the paper feed
assembly.
During assembly, when setting the compression
T
spring 1.66 to the spring installation position in the
paper feed assembly, hang the spring on the hook
temporarily. Also, do not forget to release the hooks
of these springs from the holes located on the back
of paper feed assembly by rotating the spring. (Refer
to the figure below.)
Disassembly & Assembly
LD Roller Assembly
Figure 4-10. Disassembly of Paper Feed Roller Assembly
Disassembling the Printer Mechanism
LD Roller Cover
(Right and Left)
Paper Feed Holder
Sheet
(Right and Left)
Paper Feed Assembly
(Right and Left)
During assembly, set the compression spring
1.66 in the position for spring installation of the
paper feed assembly and hang the bent part of
the spring on the hook.
Revision A
Compression Spring 1.66
+
103