Epson STYLUS Scan 2500 Service Manual page 127

EPSON Stylus Scan 2500
Figure 5-8. Sample of Head Angular Adjustment Pattern
NOTE: In the above figure, Head Katamuki means Head Angle.
4. Loosen the screw securing the printhead on the carriage. (You don't
need to remove it completely.)
Figure 5-9. Screw Position
Adjustment
NOTE: Make sure to loosen this screw. Otherwise, the printhead
5. Look very closely at the black/magenta lines in the bottom pattern and
Printhead
securing screw
6. After changing the position of the adjust lever, select Print - Angular
7. Verify the pattern on the printout again.
8. Repeat this process until the combination pattern of black/magenta is
Using the Service-Adjustment Program
angle will not change even if the adjustment lever moves.
move the adjustment lever to center the magenta lines between the
black lines. The figure below shows how to move the lever to correct
a misaligned pattern.
Correct condition = vertical
spacing is even
To move this up
Move the lever
to the front
Figure 5-10. Lever Operation
Adj. again from the Production Menu.
correct.
Revision A
To move this down
Move the lever
to the rear
Adjustment lever
125