Installation - Triumph Rocket III Service Manual

4. Carefully fit the rubber section of the tool fUlly
into the cylinder liner, positioning studss supplied
with the tool diagonally across a pair of head
bolt-holes.
1. Cylinder liner
2. Studs
3. Head-bolt holes
5. Fully engage the bolt threads in the head bolt
holes. It is not necessary to fully tighten the
bolts.
6. Turn the locking nut clockwise until the rubber
sleeve on the tool tightly grips the bore of the
liner.
7. Turn the extraction nut clockwise sufficient to
raise the liner and break the seal between the
liner and crankcase.
Note:
• It is not necessary (or possible) to fUlly
extract the liner using this tool. Once the
seal is broken, the tool must be removed
and the liner extracted by hand.
8. Turn the locking nut anticlockwise to release the
liner.
9. Once the seal on the liner is released, remove
the tool and manually remove the liner.
Crankshaft
Installation
1. Thoroughly clean the liner removing all traces of
old silicone sealer.
2. Remove all traces of sealer from the crankcase
bores.
3. Apply a thin bead of silicone sealer to the liner to
crankcase mating face.
1. Liner
2. Sealer Area
4. Apply a thin bead of silicone sealer to the liner to
crankcase mating face.
1ri-----L
1. Liner
2. Sealer area
Service Manual - Rocket III
5.19