Handlebars; Removal - Triumph Rocket III Service Manual

Handlebars
Before starting work, ensure the motorcycle is
stabilised and adequately supported. This will help
prevent it from falling and causing injury to the
operator or damage to the motorcycle.
Removal
1. Undo the screws and remove the end weights
from the handlebars.
1. Handlebar
2. Spacer
3. End weight
4. Fixing
2. Release the wiring and brake hose from its clips
on either side of the handlebar.
3. Undo the screws and free the left switchgear
assembly from the handlebar.
4. Unscrew the bolts and remove the clamp from
the clutch lever assembly.
5. Undo the screws and free the right switchgear
assembly from the front brake master cylinder.
Free the switch wiring from the handlebars.
6. Unscrew the bolts and remove the clamp from
the master cylinder.
Frame and Bodywork
7. Release the two screws securing the upper cover
of the handlebar clamp to the lower section.
1. Upper cover
2. Screws
8. Pivot the instruments forward to reveal the
handlebar clamp bolts.
1. Handlebar clamp bolts
9. Support the handlebars then unscrew the bolts
and lift off the handlebar clamp, together with the
instruments. Protect the top of the fuel tank from
accidental damage and then lay the instruments
and clamp on the fuel tank.
10. Free the handlebar from the twist-grip/master
cylinder assembly and remove it from the
motorcycle. Support the master cylinder in an
upright position.
Service Manual - Rocket III
17.15