Triumph Rocket III Service Manual page 255

Fuel tank - refit
1. Position the fuel tank to the frame and install the
rear mounting bolt.
2. Pivot the front of the tank upwards at the front
and refit the tank prop to the frame and tank
3. Tighten the rear fuel tank mounting bolt to 9 Nm.
4. Incorporating new washers, refit the fuel hose
and tighten the union to 15 Nm.
5. Reconnect the electrical supply to the fuel pump
plate.
6. Connect the breather hoses as noted/marked
prior to removal.
7. Lower and secure the fuel tank as described on
page 11.99.
Fuel System/Engine Management
Fuel Pump, Filter and Pressure
Regulator
Removal
1. Remove the fuel tank as described on page
11.100.
Observe the warning advice given in the general
information section on the safe handling of fuel and
fuel containers.
A fire, causing personal injury and damage to
property could result from spilled fuel or fuel not
handled or stored correctly.
Never drain fuel from the tank using non-approved,
non-professional standard fuel handling equipment.
A fire causing destruction of property and injury to
persons may result from use of non-approved fuel
handling equipment.
2. Using proprietary professional automotive
workshop equipment approved for fuel handling,
drain all fuel from the fuel tank.
3. Invert the fuel tank and place on a protective
surface to prevent paint damage.
4. Release the ring of nuts securing the fuel pump
mounting plate to the tank.
ob"
1. Fuel pump mounting plate
2. Nuts
~.
Service Manual - Rocket III
11.101