Engine Infill Panels; Removal; Installation; Front Mudguard - Triumph Rocket III Service Manual

Frame and Bodywork
Engine Infill Panels Front Mudguard
Engine infill panels are fitted to the frame, towards the
rear of the engine, on both sides of the motorcycle. Removal
Removal
Before starting work, ensure the motorcycle is
stabilised and adequately supported. This will help
prevent it from falling and causing injury to the
operator or damage to the motorcycle.
Before starting work, ensure the motorcycle is
stabilised and adequately supported. This will help
prevent it from falling and causing injury to the
operator or damage to the motorcycle.
1. Undo the fixings securing the mudguard shrouds
to the fork legs.
<:
1
1. Mudguard shroud
2.
Mudguard shroud fixings
3.
Fork leg
2.
Detach both shrouds.
3.
Detach the brake hoses from their clips on each
side of the mudguard.
1. Release the two screws securing each panel to
the frame.
Installation
1. Infill panel
2. Withdraw the infill panel.
Note:
• A connector bracket is located behind the
infill panel on the left hand side.
1. Position the left hand engine infill panel to the
frame. Align the screw holes in the panel with
those in the connector bracket and frame.
2. Fit the screws and tighten to 3 Nm.
3. Repeat for the right hand panel.
Note:
• There is no connector bracket on the right
hand side.
1.
Brake hoses
2.
Clips
17.10
Service Manual - Rocket III