Triumph Rocket III Service Manual page 152

Engine Removal and Refit
cbue
16. Fit and tighten the bar's mounting bolts to 27 Nm.
1. Right hand footrest mounting bar
2. Fixings
17. Position the master cylinder to the right hand
footrest mounting bar. Fit and tighten the master
cylinder bolts to 27 Nm.
18. Align the brake pedal with the pushrod, engage
the clevis and retain it with the clip. Ensure the
clip is fitted as shown below.
1. Pedal
2. Pushrod
3. Clevis
4.
Clip
19. Refit the heel guard tightening the fixings to
9Nm.
12. Position the gear change crank to the selector
shaft engaging the splines as noted during
removal.
"'"'
1. Selector rod
2. Gear change crank
3. Pinch bolt
13. Fit the pinch bolt to the crank and tighten it to
9Nm.
14. Support the rear brake master cylinder assembly
while aligning the brake pipe joint to the frame
outrigger. Tighten the bolt retaining the brake
pipe joint to 20 Nm.
1. Brake pipe joint
2. Fixing
15. Position the right hand footrest mounting bar to
the frame and engine.
10.6
Service Manual - Rocket III