Triumph Rocket III Service Manual page 256

Fuel System/Engine Management
7. To release the pressure regulator, release the
hose clips from the pump plate and filter then
gently ease the regulator, link pipe and hoses
upwards. Place the regulator aside.
cbpb
1. Pressure regulator
2. Hose clips
3. Link pipe
4. Pump mounting plate
Note:
• Prior to removing the filter, note the
direction of the arrow on the side of the
filter. The arrow should point away from
the fuel pump, towards the pressure
regulator.
8.
To release the fiiter, release the hose clip and
gently ease the filter from the inlet hose.
Ensure that the fuel level sensor's float arm is not
damaged during removal of the fuel pump mounting
plate. A damaged float arm will result in an
Incorrectly operating low fuel warning light.
5. Separate the pump/filter/regulator assembly from
the fuel tank. Discard the pump plate seal.
Note:
• To remove the pressure regulator, filter
and pump, components must be removed
in sequence, as follows below/over.
6. Release the screw securing the pressure
regulator to the mounting bar.
"'"
1. Screw
2. Pressure regulator
Note:
• Unless it cannot be avoided, do not cut the
tie securing the internal wiring to the fuel
pressure regulator. Instead, release the
two wiring connectors from the pump plate
(note or mark their positions before
removal).
1. Filler
2. Clip
3. Inlet hose
4. Filler arrow
11.102
Service Manual - Rocket I11