Triumph Rocket III Service Manual page 151

Installation
Note:
• As the frame is being lowered onto the
engine, reconnect the low oil pressure
warning light switch and attach the
breather hose.
1. Locate the frame to the engine aligning the
engine mounting points with the corresponding
positions on the frame.
2. Install the engine mounting bolts and nuts, but do
not tighten any yet.
1.
Lower rear mounting bolt (one per side)
2. Upper rear mounting bolt (one per side)
3.
Front mounting boil
3. Tighten the engine mounting bolts, nuts,
adjusters and adjuster collars in the following
sequence:
• Tighten the upper and lower left hand rear
engine mounting bolts and nuts to 80 Nm.
• Support the frame and engine, and
temporarily remove the rear right hand
mounting bolts.
• Tighten the right hand rear adjusters to 5 Nm.
• Refit the rear right hand mounting bolts.
• Tighten the upper and lower rear right hand
engine mountings to 80 Nm.
• Using service tool T3880063, tighten the
locking collars on both right hand engine
mounting adjusters to
55
Nm.
• Tighten the front engine mounting bolt and
nut to 80 Nm.
Engine Removal and Refit
4. Reconnect the remaining electrical connections
to the engine. These include:
• Low oil pressure warning light switch
• Crankshaft position sensor
• Gear position sensor
• Road speed sensor
• Coolant temperature sensor
• Battery earth
• Starter motor connections
5.
Attach and secure the engine breather hose with
its clip.
6. Position the airbox to its mountings, fit and
tighten its bolts to 9 Nm.
7.
Refit the side stand, tightening the fixings to
40Nm.
8. Reconnect the side stand switch.
9.
Reconnect the spark plug leads.
10. Position the left hand footrest mounting bar to the
frame and engine.
11. Fit and tighten the bar's mounting bolts to 27 Nm.
1. Left hand footrest mounting bar
2. Fixings
Service Manual - Rocket III
10.5