Triumph Rocket III Service Manual page 284

Fuel System/Engine Management
Idle Speed Control Stepper Motor
Removal
7. Remove the two screws securing the idle speed
control stepper motor to its bracket, then remove
the stepper motor.
1. Remove the rider's seat.
3
2. Disconnect the battery, negative (black) lead first.
3. Remove the throttle bodies as described on page
11.122.
4. Remove the nut, metal washer and plastic
washer attaching the idle control stepper arm to
the idle speed control lever.
{}
ccai
/~
...
y \
=-
1. Idle speed control stepper motor
2. Bracket
3. Fixings
Installation
1. Turn the idle speed control lever until it the
stepper motor can be fitted without obstruction of
any kind.
2. Locate the stepper motor to its bracket and
tighten the fixings to 3.5 Nm.
3. Locate the spring and plastic collar.
1. Collar
2. Spring
4. Fit the plastic washer through the lever then fit
the metal washer and nut.
5. Refit the throttle bodies as described earlier in
this section, but do not fit the intake cover.
6. Temporarily reconnect the battery, positive (red)
lead first.
7. Turn the ignition to the ON position.
8. Connect the service diagnostic tool and scroll
through to, and select the 'ADJUST TUNE'
option.
1. Idle control stepper arm
2. Idle speed control lever
3. Nut etc.
5. Using the linkage, rather than the butterfly plates,
fully open the primary throttle by hand.
6. Turn the idle speed control lever away from the
stepper arm and remove the plastic collar and
spring.
1. Collar
2. Spring
11.130
Service Manual - Rocket III