Brother HL-7050 Service Manual page 56

CHAPTER 2 INSTALLATION AND BASIC OPERATION
Most envelopes will perform acceptably on the HL-7050 printer. However, some envelopes will
have feed and print quality problems because of their construction. A suitable envelope should
have edges with straight, well creased folds and should not have more than two thicknesses of
paper along the leading edge. The envelope should lie flat and not have baggy or flimsy
construction. Purchase quality envelopes only from a supplier who understands that the
envelopes will be used in a laser printer. All envelopes should be tested prior to use to ensure
desirable print results.
NOTE:
The manufacturer neither warrants nor recommends the use of a particular envelope because
envelope properties are subject to change by the envelope manufacturer. The entire
responsibility for the quality and performance of envelopes lies with the customer.
4.4 Printing on Label, Transparency, etc.
Use of any of the types of paper listed below may cause damage to your printer. Such
damage is not covered under any warranty or service agreement.
NOTE:
Before using paper with holes, such as organizer sheets, fan the stack well to avoid paper
jams and misfeeds.
Do not use paper with perforations at the edges.
Do not place the punch hole near the actuator (paper sensor).
Do not use organizer sheets that are stuck together. The glue that is used might cause
damage to the printer.
Do not load different types of paper at the same time in the paper tray because it may
cause paper jams or misfeeds.
For correct printing, select the same paper size from within the software application as the
paper in the tray.
If the application software does not support paper size selection on its print menu, the
paper size on the printer's control panel under the PAPER menu can be changed. For
more information, see
(1) Open the MP tray and lower it gently.
subsection 5.5.2 'Paper' in this
Fig.2-41
2-26
chapter.