Brother HL-7050 Service Manual page 38

CHAPTER 2 INSTALLATION AND BASIC OPERATION
3.1.4 Print a test page
(1) Make sure the printer power switch is off. Connect the AC power cord to the printer.
Do NOT connect the interface cable.
(2) Plug the AC power cord into an AC outlet, and then turn on the power switch.
(3) After the printer has finished warming up, the READY message appears on the LCD
display of the control panel.
(4) Press the Go button. The printer prints a test page. Check that the test page has printed
correctly.
NOTE:
This function cannot be used if data is sent from PC after connecting the interface cable.
3.2 For Parallel Interface Cable Users (for Windows users only)
Follow the steps below only after completing steps 3.1.1 through to 3.1.4 above.
Connect the printer to your PC & Install the printer driver
(1) Turn off the printer power switch.
(2) Connect the parallel interface cable to your PC, and then connect it to your printer.
(3) Turn on the printer power switch.
Note:
If the "Found New Hardware Wizard" appears on your PC, click the Cancel button.
(4) Put the CD-ROM into your CD-ROM drive. The opening screen will appear automatically.
Follow the instruction on the screen.
Fig. 2-10
2-8