Modifying Normal-Range Vlans; Configuring Extended-Range Vlans On The Switch; Extended-Range Vlan Configuration Guidelines - Cisco WS-C6506 Software Manual

Catalyst 6500 series switch

Hide thumbs Also See for WS-C6506:

Table of Contents

---- ----- ---------- ----- ------ ------ ------ ---- -------- ------ ------

VLAN AREHops STEHops Backup CRF

---- ------- ------- ----------

Console> (enable)

Modifying Normal-Range VLANs

To modify the VLAN parameters on an existing normal-range VLAN, perform this task in privileged

Modify an existing normal-range VLAN. set vlan vlan [name name] [state {active | suspend}]

Verify the VLAN configuration.

Configuring Extended-Range VLANs on the Switch

These sections explain how to configure extended-range VLANs 1025–4094:

This section describes the guidelines for creating extended-range VLANs 1024–4094:

Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7

Extended-Range VLAN Configuration Guidelines, page 11-6

Creating Extended-Range VLANs, page 11-7

You can create only Ethernet-type VLANs in the extended range.

You must enable MAC address reduction in order to use the extended-range VLANs.

You can only create and delete the extended-range VLANs from the CLI or SNMP.

You cannot use VTP to manage these VLANs; they must be statically configured on each switch.

With VTP version 3, you can manage VLANs 1006–4094. These VLANs are propagated

with VTP version 3. For configuration purposes, the extended range consists of

VLANs 1025–4094.

You cannot use the extended-range VLANs if you have dot1q-to-isl mappings.

Parent RingNo BrdgNo Stp

[said said] [mtu mtu] [translation vlan]

show vlan [vlan]

Configuring VLANs

BrdgMode Trans1 Trans2

Show Quick Links

Table of Contents

Catalyst 6506 Catalyst 6509 Catalyst 6513