L2 Switch > Radius - Cisco RVS4000 - Gigabit Security Router Administration Manual

Setting Up and Configuring the Router
L2 Switch
Cisco RVS4000 Security Router with VPN Administrator Guide
L2 Switch > RADIUS
L2 Switch > RADIUS
Mode Select Enabled or Disabled from the drop-down menu to enable or disable
RADIUS.
RADIUS IP Enter the Server IP address.
RADIUS UDP Port Enter the UDP port. The UDP port is used to verify the RADIUS
server authentication.
RADIUS Secret Enter the Key string for authenticating and encrypting all RADIUS
communications between the device and the RADIUS server. This key must match
the RADIUS server encryption key. If no host-specific value is specified, the global
value applies to each host.
Administration State
values are:
• Auto The controlled port state is set by the Authentication method.
• Force Authorized
(forward traffic).
• Force Unauthorized
(discard traffic).
Port State Displays the state of the selected port.
Specifies the port authorization state. The possible field
The controlled port state is set to Force-Authorized
The controlled port state is set to Force-Unauthorized
5
90