Setting Up and Configuring the Router
Setup
Cisco RVS4000 Security Router with VPN Administrator Guide
Network Setting Status
LAN IP
The IP address of the router's LAN interface.
WAN IP
The IP address of the router's WAN interface. If this address was assigned
by using DHCP, click DHCP Release to release the address, or click DHCP Renew
to renew the address.
Mode
The operating mode, Gateway or Router.
Gateway
The Gateway address, which is the IP address of your ISP's server.
DNS 1-2
The IP addresses of the Domain Name System (DNS) server(s) that the
router is using.
DDNS
Indicates whether the Dynamic Domain Name System (DDNS) feature is
enabled.
DMZ
Indicates whether the DMZ hosting feature is enabled.
Firewall Setting Status
DoS (Denial of Service)
to block DoS attacks.
Block WAN Request
enabled.
Remote Management
enabled.
IPSec VPN Setting Status
IPSec VPN Summary
VPN > Summary window.
Tunnel(s) Used
Displays the number of VPN tunnels currently in use.
Tunnel(s) Available
Displays the number of VPN tunnels that are available.
Log Setting Status
Email
If this displays Email cannot be sent because you have not specified an
outbound SMTP server address, then you have not set up the mail server. Click
the Email hyperlink to display the Administration > Log window where you can
configure the SMTP mail server.
Indicates whether the DoS Protection feature is enabled
Indicates whether the Block WAN Request feature is
Indicates whether the Remote Management feature is
Click the IPSec VPN Summary hyperlink to display the
5
28