Avaya PARTNER Advanced Communications System Quick Reference Manual page 65

Quick Reference Guide
Backup Programming—Automatic (#123)
Use this feature to set up the automatic backup of all programming (except the
system date, and time). When Backup Programming—Automatic is set to Active
Internal or Active PC Card, the information is backed up at 2:00 a.m. on the next
day to either the internal memory of the processor module or a Backup/Restore
PC Card. From that point onward, the information is backed up at 2:00 a.m. on
the first day of each month to either the internal memory of the processor module
or a Backup/Restore PC Card. Active Internal scheduled backups and system
initiated backups are stored in the same file.
If Backup Programming—Automatic is Active Internal or Active PC Card and an
automatic backup fails, a Backup-Failure Alarm message appears (instead of the
system date and time) on the top line of the telephone display at idle Extensions
10 and 11.
See Chapter 7, "If Something Doesn't Work'
messages and suggested corrective actions, and for the procedure for clearing
the Backup-Failure Alarm message.
To change the setting for Backup Programming—Automatic:
If you want to back up to a PC Card, check that only one Backup/Restore
1
PC Card is in the processor module.
f00ss#123
Press
2
10 or 11.
To change the setting, press
3
appears, or press
possible settings are:
• 1 = Active Internal
• 2 = Active PC Card
• 3 = Not Active (the factory setting)
• 4 = Backup Alarm Cleared
Exit programming mode.
4
For information about using Option 4, Backup Alarm Cleared, see
Backup-Failure Alarm" on page
D
r
to return the setting to the factory setting. The
88.
6 Maintaining Your System
for an explanation of these
d
or until the setting you want

Backup and Restore
at extension
"Clearing a
65