Troubleshooting Uplink Module Installation Or Replacement On J-Ex4200 Switches; Virtual Chassis Port (Vcp) Connection Does Not Work - Dell PowerConnect J-EX4200 Hardware Manual

Dell PowerConnect J-Series J-EX4200 Ethernet Switch Hardware Guide

Troubleshooting Uplink Module Installation or Replacement on J-EX4200 Switches

Virtual Chassis port (VCP) connection does not work

Problem
Cause
Solution
Related
Documentation
158
Uplink Modules in J-EX4200 Switches on page 25
This topic provides troubleshooting information for specific problems related to uplink
module ports on J-EX4200 switches.
1. Virtual Chassis port (VCP) connection does not work on page 158
The Virtual Chassis port (VCP) connection configured in a J-EX4200 switch does not
work.
A port of the uplink module is set as a VCP.
The uplink module installed in the switch was replaced.
Set a port in the uplink module as a VCP. For instructions, see the Dell PowerConnect
J-Series Ethernet Switch Complete Software Guide for Junos OS at
http://www.support.dell.com/manuals
For information about J-EX4200 switch interfaces, interface configuration, and interface
monitoring, see the Dell PowerConnect J-Series Ethernet Switch Complete Software
Guide for Junos OS at
http://www.support.dell.com/manuals
Installing an Uplink Module in a J-EX4200 Switch on page 108
Removing a Transceiver from a J-EX Series Switch on page 144
Uplink Modules in J-EX4200 Switches on page 25
Understanding Virtual Chassis Hardware Configuration on a J-EX4200 Switch on
page 75
.
.