Removing A Fan Tray From A J-Ex4200 Switch - Dell PowerConnect J-EX4200 Hardware Manual

Related
Documentation

Removing a Fan Tray from a J-EX4200 Switch

Place one hand under the power supply to support it and slide it completely out of
7.
the chassis. Take care not to touch power supply components, pins, leads, or solder
connections.
Place the power supply in the antistatic bag or on the antistatic mat placed on a flat,
8.
stable surface.
Figure 56: Removing a Power Supply from a J-EX4200 Switch
Installing a Power Supply in a J-EX4200 Switch on page 106
Installing and Removing J-EX4200 Switch Hardware Components on page 105
Power Supply in J-EX4200 Switches on page 21
Field-Replaceable Units in J-EX4200 Switches on page 16
AC Power Cord Specifications for J-EX4200 Switches on page 71
Rear Panel of a J-EX4200 Switch on page 7
J-EX4200 switches have a single fan tray on the rear panel. The fan tray is a hot-removable
and hot-insertable field-replaceable unit (FRU): You can remove and replace it without
powering off the switch or disrupting switch functions.
Ensure that you have the following parts and tools available:
Phillips (+) screwdriver, number 2
An antistatic bag or an antistatic mat
To remove a fan tray from a J-EX4200 switch (see Figure 57 on page 142):
Place the antistatic bag or the antistatic mat on a flat, stable surface.
1.
Loosen the screw or screws securing the fan tray by using the screwdriver.
2.
Chapter 13: Removing Switch Components
141