Connecting A J-Ex Series Switch To A Network For Out-Of-Band Management - Dell PowerConnect J-EX4200 Hardware Manual

Dell PowerConnect J-Series J-EX4200 Ethernet Switch Hardware Guide

Connecting a J-EX Series Switch to a Network for Out-of-Band Management

Related
Documentation
120
You can monitor and manage a J-EX Series switch using a dedicated management
channel. J-EX Series switches have a management port with an RJ-45 connector for
out-of-band management. Use the management port to connect the J-EX Series switch
to the management device.
Ensure that you have an Ethernet cable with an RJ-45 connector available. One such
cable is provided with the switch. Figure 48 on page 120 shows the RJ-45 connector of
the Ethernet cable supplied with the switch.
Figure 48: Ethernet Cable Connector
To connect a J-EX Series switch to a network for out-of-band management (see Figure
49 on page 120):
Connect one end of the Ethernet cable to the management port (labeled
1.
the J-EX Series switch.
For the location of the
Connect the other end of the Ethernet cable to the management device.
2.
Figure 49: Connecting a J-EX Series Switch to a Network for Out-of-Band
Management
Connecting a J-EX Series Switch to a Management Console on page 121
Management Port Connector Pinout Information for a J-EX4200 Switch on page 31
port, see "Rear Panel of a J-EX4200 Switch" on page 7.
MGMT
) on
MGMT