Component Specifications; Chapter 3 Component Specifications; Usb Port Specifications For A J-Ex Series Switch - Dell PowerConnect J-EX4200 Hardware Manual

CHAPTER 3

Component Specifications

USB Port Specifications for a J-EX Series Switch

Related
Documentation
USB Port Specifications for a J-EX Series Switch on page 29
Network Port Connector Pinout Information for a J-EX4200 Switch on page 30
Console Port Connector Pinout Information for a J-EX Series Switch on page 30
Management Port Connector Pinout Information for a J-EX4200 Switch on page 31
Optical Interface Support in J-EX4200 Switches on page 32
Uplink Modules Connector Pinout Information for J-EX4200 Switches on page 41
Virtual Chassis Ports Connector Pinout Information for J-EX4200 Switches on page 49
The following Dell USB flash drives have been tested and are officially supported for the
USB port on all J-EX Series switches:
1-GB USB flash drive (WFXDH)
2-GB USB flash drive (T8GCH)
4-GB USB flash drive (7XMF7)
CAUTION: Any USB memory product not listed as supported for J-EX Series
switches has not been tested. The use of any unsupported USB memory
product could expose your switch to unpredictable behavior. Dell can provide
only limited support for issues related to unsupported hardware. We strongly
recommend that you use only supported USB flash drives.
All USB flash drives used on the switches must have the following features:
USB 2.0 or later
Formatted with a FAT or MS-DOS file system
See Front Panel of a J-EX4500 Switch for port location.
For information about booting the switch from a software package stored on a USB
flash drive, see the Dell PowerConnect J-Series Ethernet Switch Complete Software
Guide for Junos OS at
http://www.support.dell.com/manuals
.
29