Setting The Mode On An Sfp+ Uplink Module (Cli Procedure) - Dell PowerConnect J-EX4200 Hardware Manual

Related
Documentation

Setting the Mode on an SFP+ Uplink Module (CLI Procedure)

Related
Documentation
If you use the J-Web interface to continue configuring the switch, the Web session is
redirected to the new management IP address. If the connection cannot be made, the
J-Web interface displays instructions for starting a J-Web session.
Connecting and Configuring a J-EX Series Switch (CLI Procedure) on page 131
Installing and Connecting a J-EX4200 Switch on page 87
SFP+ uplink modules are supported on J-EX4200 switches. You can use these uplink
modules either for two SFP+ transceivers or four SFP transceivers. You configure the
operating mode on the module to match the type of transceiver you want to use—for
SFP+ transceivers, you configure the 10-gigabit operating mode, and for SFP transceivers,
you configure the 1-gigabit operating mode.
By default, the SFP+ uplink module operates in the 10-gigabit mode and supports only
SFP+ transceivers. If you have not changed the module from the default setting and you
want to use SFP+ transceivers, you do not need to configure the operating mode.
To set the operating mode of an SFP+ uplink module:
Change the operating mode to the appropriate mode for the transceiver type you
1.
want to use by using one of the following commands:
[edit]
user@switch# set chassis fpc 0 pic 1 sfpplus pic-mode 1g
[edit]
user@switch# set chassis fpc 0 pic 1 sfpplus pic-mode 10g
Reboot the switch.
2.
If you commit the configuration but then do not reboot the switch, the new configuration
does not take effect and the operating mode of the uplink module is not changed.
You can see whether the operating mode has been changed to the new mode you
configured by issuing the
Uplink Modules in J-EX4200 Switches on page 25
Optical Interface Support in J-EX4200 Switches on page 32
show chassis pic fpc-slot slot-number pic-slot 1
Chapter 12: Performing Initial Configuration
command.
135