Mounting A J-Ex4200 Switch On A Desk Or Other Level Surface - Dell PowerConnect J-EX4200 Hardware Manual

Related
Documentation

Mounting a J-EX4200 Switch on a Desk or Other Level Surface

In a position recessed 2 in. from the front of a 19-in. rack or cabinet by using the
2-in.-recess front brackets in the separately orderable four-post rack-mount kit. You
can mount the switch in this recessed position on two-post or four-post racks and
cabinets.
On a desk or other level surface by using rubber feet. The switch is shipped with four
rubber feet to be used to stabilize the chassis on a desk or other level surface.
On a wall by using the separately orderable wall-mount kit.
The holes in the mounting brackets are placed at 1 U (1.75 in. or 4.45 cm.) apart so that
the switch can be mounted in any rack or cabinet that provides holes spaced at that
distance.
Mounting a J-EX4200 Switch on Two Posts in a Rack or Cabinet on page 92
Mounting a J-EX4200 Switch on Four Posts in a Rack or Cabinet on page 96
Mounting a J-EX4200 Switch in a Recessed Position in a Rack or Cabinet on page 100
Mounting a J-EX4200 Switch on a Desk or Other Level Surface on page 91
Mounting a J-EX4200 Switch on a Wall on page 100
Connecting Earth Ground to a J-EX Series Switch on page 115
You can mount a J-EX4200 switch on a desk or other level surface by using the 4 rubber
feet that are shipped with the switch. The rubber feet stabilize the chassis.
Before mounting a J-EX4200 switch on a desk or other level surface:
Verify that the site meets the requirements described in "Site Preparation Checklist
for J-EX4200 Switches" on page 57.
Place the desk in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
Read "General Safety Guidelines and Warnings for J-EX Series Switches" on page 171,
with particular attention to "Chassis Lifting Guidelines for J-EX4200 Switches" on
page 184.
Remove the switch from the shipping carton (see "Unpacking a J-EX4200 Switch" on
page 88).
Ensure that you have the following parts and tools available:
4 rubber feet to stabilize the chassis on the a desk or other level surface (provided in
the accessory box shipped with the switch)
Dust covers for ports (for J-EX4200-24F switches only; optional)
To mount the switch on a desk or other level surface:
Chapter 9: Installing the Switch
91