Replacing A Member Switch Of A Virtual Chassis Configuration; Procedure) - Dell PowerConnect J-EX4200 Hardware Manual

Dell PowerConnect J-Series J-EX4200 Ethernet Switch Hardware Guide
Related
Documentation
Replacing a Member Switch of a Virtual Chassis Configuration (CLI Procedure)
148
Figure 61: Virtual Chassis Cable Connector in a J-EX4200 Switch
NOTE: If you order Virtual Chassis cables separately, you must reuse the
cable connector retainers provided with the original cable or order Virtual
Chassis cable connector retainers also separately.
Connecting a Virtual Chassis Cable to a J-EX4200 Switch on page 112
Understanding Virtual Chassis Hardware Configuration on a J-EX4200 Switch on
page 75
For information about Virtual Chassis components, see the Dell PowerConnect J-Series
Ethernet Switch Complete Software Guide for Junos OS at
http://www.support.dell.com/manuals
Planning the Virtual Chassis on page 76
Virtual Chassis Ports Connector Pinout Information for J-EX4200 Switches on page 49
You can replace a member switch of a J-EX4200 Virtual Chassis, a J-EX4500 Virtual
Chassis, or a mixed J-EX4200 and J-EX4500 Virtual Chassis without disrupting network
service for the other members. You can retain the existing configuration of the member
switch and apply it to a new member switch, or you can free up the member ID and make
it available for assignment to a new member switch.
Virtual Chassis cable connector
Release pull tab
Cable connector retainer
.