Card Configuration; Table 6: Switch Configuration Fields - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
Field
Broadcast Storm
Recovery Mode
Broadcast Storm
Recovery Level
Multicast Storm
Recovery Mode
Multicast Storm
Recovery Level
Unicast Storm
Recovery Mode
Unicast Storm
Recovery Level
IEEE 802.3x Flow
Control Mode
• If you change the mode, click Submit to apply the changes to the system. If you want the switch to retain the new
values across a power cycle, you must perform a save.
C C
ARD ONFIGURATION
Use the Card Configuration page to view information about the cards installed in a switch.
To access the Card Configuration page, click LAN > Administration > Card Configuration in the navigation menu.
Figure 12 shows the fields that display when the slot contains a card.
Document 34CSFP6XXUWS-SWUM100-D7

Table 6: Switch Configuration Fields

Description
Enable or disable this option by selecting one of the following options:
• Enable: When the broadcast traffic on on any Ethernet port exceeds the configured threshold,
the switch blocks (discards) the broadcast traffic.
• Disable: The switch does not block broadcast traffic if traffic exceeds the configured threshold
on any Ethernet port. The factory default is disabled.
Specify the data rate at which storm control activates. The value is a percentage of port speed
and ranges from 0-100. The factory default is 5 percent of port speed.
Enable or disable this option by selecting one of the following options on the pulldown entry
field:
• Enable: When the multicast traffic on any Ethernet port exceeds the configured threshold, the
switch blocks (discards) the multicast traffic.
• Disable: The switch does not block multicast traffic if traffic on any Ethernet port exceeds the
configured threshold. The factory default is disabled.
Specify the data rate at which storm control activates. The value is a percentage of port speed
and ranges from 0-100. The factory default is 5 percent of port speed.
Enable or disable this option by selecting one of the following options on the pulldown entry
field:
• Enable: When the unicast traffic on any Ethernet port exceeds the configured threshold, the
switch blocks (discards) the unicast traffic.
• Disable: The switch does not block unicast traffic if the unicast traffic on any port exceeds the
configured threshold. The factory default is disabled.
Specify the data rate at which storm control activates. The value is a percentage of port speed
and ranges from 0-100.The factory default is 5 percent of port speed.
Enables or disables IEEE 802.3x flow control on the system. The factory default is disabled.
• Enable: Enables flow control so that the switch can communicate with higher speed switches.
• Disable: Disables flow control so that the switch does not send pause packets if the port
buffers become full.
D-Link Unified Access System

Card Configuration

Page 61