Using The Command-Line Interface; Figure 6: Help Link - D-Link DWS-4026 User Manual

D-Link Unified Access System
Figure 1 on page 49 shows the location of the Help link on the Web interface.
U C
SING THE OMMAND
The command-line interface (CLI) is a text-based way to manage and monitor the system. You can access the CLI by using
a direct serial connection or by using a remote logical connection with telnet or SSH.
The CLI groups commands into modes according to the command function. Each of the command modes supports specific
software commands. The commands in one mode are not available until you switch to that particular mode, with the
exception of the User EXEC mode commands. You can execute the User EXEC mode commands in the Privileged EXEC
mode.
To display the commands available in the current mode, enter a question mark (?) at the command prompt. To display the
available command keywords or parameters, enter a question mark (?) after each word you type at the command prompt.
If there are no additional command keywords or parameters, or if additional parameters are optional, the following message
appears in the output:
<cr>
For more information about the CLI, see the D-Link CLI Command Reference.
The D-Link CLI Command Reference lists each command available from the CLI by the command name and provides a brief
description of the command. Each command reference also contains the following information:
• The command keywords and the required and optional parameters.
• The command mode you must be in to access the command.
• The default value, if any, of a configurable setting on the device.
The show commands in the document also include a description of the information that the command shows.
Page 52 Understanding the User Interfaces

Figure 6: Help Link

-L I
INE NTERFACE
Press Enter to execute the command
Software User Manual
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09