Ip Dscp Mapping Configuration; Cos Interface Configuration; Figure 238: Ip Dscp Mapping Configuration; Table 214: Ip Dscp Mapping Configuration Fields - D-Link DWS-4026 User Manual

D-Link Unified Access System
IP DSCP M
APPING
Use the IP DSCP Mapping Configuration page to map an IP DSCP value to an internal traffic class.
To display the IP DSCP Mapping Configuration page, click LAN >QoS > Class of Service > IP DSCP Mapping
Configuration in the navigation menu.
Field
Slot/Port
IP DSCP Values
Traffic Class
• If you make changes to the page, click Submit to apply the changes to the system. Click Restore Defaults to reset all
interfaces to the default trust value.
C S I C
O NTERFACE ONFIGURATION
Use the CoS Interface Configuration page to apply an interface shaping rate to all ports or to a specific port.
To display the CoS Interface Configuration page, click LAN > QoS > Class of Service > CoS Interface Configuration in
the navigation menu.
Page 338 Configuring Class of Service
C
ONFIGURATION

Figure 238: IP DSCP Mapping Configuration

Table 214: IP DSCP Mapping Configuration Fields

Description
The menu contains all CoS configurable interfaces. The only option is Global, which
means that the IP DSCP mapping configuration applies to all interfaces and cannot be
applied on a per-interface basis.
Lists the IP DSCP values to which you can map an internal traffic class. The values
range from 0-63.
The traffic class is the hardware queue for a port. Higher traffic class values indicate a
higher queue position. Before traffic in a lower queue is sent, it must wait for traffic in
higher queues to be sent. Valid range is 0 to 7.
Software User Manual
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09