Figure 250: Captive Portal Global Configuration; Table 223: Captive Portal Global Configuration - D-Link DWS-4026 User Manual

D-Link Unified Access System
The following table describes the global CP fields you can view or configure.
Field Description
Enable Captive Select the check box to enable the CP feature on the switch. Clear the check box to disable the
Portal captive portal feature.
CP Global Shows whether the CP feature is enabled.
Operational Status
CP Global Disable If CP is disabled, this field displays the reason, which can be one of the following:
Reason
• None
• Administratively Disabled
• No IPv4 Address
• Routing Enabled, but no IPv4 routing interface
Additional HTTP HTTP traffic uses port 80, but you can configure an additional port for HTTP traffic. Enter a port
Port number between 0-65535 (excluding ports 80, 443, and the configured switch management
secure port).
Additional HTTP HTTP traffic over SSL (HTTPS) uses port 443, but you can configure an additional port for HTTPS
Secure Port traffic. Enter a port number between 0-65535 (excluding ports 80, 443, and the configured switch
management secure port).
Peer Switch When clustering is supported on the switch, enter a value to determine how often the switch sends
Statistics Reporting its authenticated client statistics to the Cluster Controller. The interval is in seconds. Enter a value
Interval of 0 to prevent the switch from reporting the statistics.
Authentication To access the network through a portal, the wireless client must first enter authentication
Timeout information on an authentication Web page. Enter the number of seconds to keep the
authentication session open with the client. When the timeout expires, the switch disconnects any
active TCP or SSL connection with the client.
Page 360 Captive Portal Configuration

Figure 250: Captive Portal Global Configuration

Table 223: Captive Portal Global Configuration

Software User Manual
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09