Viewing Detected Client Triangulation; Figure 344: Detected Client Triangulation; Table 320: Detected Client Pre-Authentication History; Table 321: Detected Client Triangulation - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
Field
MAC Address
AP MAC Address
Radio Interface Number Radio number to which the client is authenticated, which is either Radio 1 or Radio 2.
VAP MAC Address
SSID
Age
User Name
Pre-Authentication
Status

Viewing Detected Client Triangulation

The Detected Client Triangulation page lists up to three non-sentry and three sentry managed APs that have detected the
client. The signal strength reported by the APs can help triangulate the location of the client. Since an AP can have one radio
configured in sentry mode and another radio configured in non-sentry mode, the same AP might appear in both lists. If the
AP or the Client has not been detected by three APs, the list can contain zero, one or two entries.
Table 321 describes the fields on the Detected Client Triangulation page.
Field
Detected Client MAC
Address
Sentry
MAC Address
Radio
RSSI
Document 34CSFP6XXUWS-SWUM100-D7

Table 320: Detected Client Pre-Authentication History

Description
MAC address of the client.
MAC Address of the managed AP to which the client has pre-authenticated.
VAP MAC address to which the client roamed.
SSID Name used by the VAP.
Time since the history entry was added.
Indicates the user name of client that authenticated via 802.1X.
Indicates whether the client successfully authenticated and shows a status of Success or
Failure.

Figure 344: Detected Client Triangulation

Table 321: Detected Client Triangulation

Description
MAC address of the client.
Identifies whether the radio that detected the client is in sentry or non-sentry mode.
• Non-Sentry: The radio that detected the client is not configured in sentry mode. This means
the radio can accept connections from wireless clients and send and receive traffic
• Sentry: The radio that detected the client is configured in sentry mode. Networks that deploy
sentry APs or radios can detect devices on the network quicker and perform more thorough
security analysis.
MAC Address of the managed AP that detected the client.
Radio number to which the client is authenticated, which is either Radio 1 or Radio 2.
Received signal strength indicator in terms of percentage for the non-sentry AP. The range is
0–100, where the maximum value is 100. A value of 0 indicates that the client is not detected.
D-Link Unified Access System
Monitoring and Managing Intrusion Detection Page 499