Avaya Ip600 Site Requirements - Avaya IP600 Overview

Hardware

Avaya IP600 Site Requirements

6
Figure 1. Avaya IP600 Rack-Mounted Cabinet
Grounding Receptacle
1
650A Power Supply
2
TN795 Processor
3
TN744D Call-Classifier-
4
Detector
TN799B/C C-LAN
5
Slots 1 and 2 are reserved for the TN795 circuit pack. Slot 3 is recommended for the
TN744D circuit pack, but any other slot is acceptable.
Avaya IP 600 is designed to be mounted in a standard 19-inch (48 cm) data rack that
has been properly pre-installed and secured as per the EIA 464 (or equivalent)
standards. The Avaya 1P600 cabinet can be front mounted (as shipped) or mounted at
its midpoint.
The customer is responsible for providing the rack and having it installed and secured
prior to Avaya IP600 installation. This also applies to providing AC power to the
rack. The technicians trained to install the Avaya IP600 do not typically have the
tools or proper training for data rack installation.
Installation requires 1 foot (30 cm) of clearance in the rear, and 18 inches (45 cm) of
clearance in the front, which is consistent with the EIA 464 data rack standards. In a
two-cabinet configuration, the dimensions of the TDM/LAN cable require that the
B cabinet be mounted directly over the A cabinet (flush).
TN2302AP IP Media Processor
6
Storage Area (containing grounding
7
wrist strap, backup PCMIA
flashcard, and documentation
library CD)
Fiber pass-through area
8
Overview for Avaya IP600 Internet Protocol Communications Server
555-233-001 — Issue 5 — November 2000
1