Radius Commands - Avaya P334T-ML Installation and configuration guid Installation And Configuration Manual

Radius Commands

The following RADIUS commands are accessible from Supervisor level.
In order to...
Enable or disable authentication for
the P330 switch. RADIUS
authentication is disabled by
default
Set a primary or secondary
RADIUS server IP address
Configure a character string to be
used as a "shared secret" between
the switch and the RADIUS server
Set the RFC 2138 approved UDP
port number.
Set the number of times an access
request is sent when there is no
response
Set the time to wait before
re-sending an access request
Remove a primary or secondary
RADIUS authentication server
Display all RADIUS authentication
configurations. Shared secrets are
not displayed.
For a complete description of the RADIUS CLI commands, including syntax and
output examples, refer to Avaya P330: Reference Guide.
Avaya P334T-ML User's Guide
Chapter 8
Use the following command...
set radius authentication
set radius authentication server
set radius authentication secret
set radius authentication udp-port
set radius authentication
retry-number
set radius authentication retry-time
clear radius authentication server
show radius authentication
User Authentication
51