Rip2; Rip Cli Commands - Avaya P334T-ML Installation and configuration guid Installation And Configuration Manual

Stackable switch software version 4.5
Hide thumbs Also See for P334T-ML Installation and configuration guid:
Table of Contents

Advertisement

Chapter 12
Avaya P330 Layer 3 Features

RIP2

RIP2 overcomes some of the shortcomings of RIP. The table below summarizes the
differences between RIP and RIP2.
Table 12.1
RIP2
Multicast addressing
Event-driven
VLSM support (subnet information
transmitted)

RIP CLI Commands

In order to...
Configure the Routing Information
Protocol (RIP)
Specify a list of networks on which
the RIP is running
Redistribute routing information
from other protocols into RIP
Specify the RIP version running on
the interface basis
Set the interface RIP route metric
value
Set the RIP Send and Receive mode
on an interface
Enable learning of the default route
received by the RIP
Enable split-horizon with poison-
reverse on an interface
Enable split-horizon mechanism
132
DIfferences Between RIP and RIP2
RIP
Broadcast Addressing
Timer-based (update every 30
seconds)
Fixed subnet masks
Use the following command...
router rip
network
redistribute
ip rip rip-version
default-metric
ip rip send-receive
ip rip default-route-mode
ip rip poison-reverse
ip rip split-horizon
Avaya P334T-ML User's Guide

Advertisement

Table of Contents
loading

Table of Contents