Calibrate:data; Calibrate:level; Calibrate:password; Calibrate:save - Agilent Technologies 66312A Programming Manual

CALibrate:DATA

This command enters a calibration value that you obtain by reading an external meter. You must first
select a calibration level (with CALibrate:LEVel) for the value being entered.
Command Syntax
Parameters
Examples
Related Commands

CALibrate:LEVel

This command selects the next point in the calibration sequence.
P1: the first calibration point
P2: the second calibration point
Command Syntax
Parameters
Examples

CALibrate:PASSword

This command lets you change the calibration password. A new password is automatically stored in
nonvolatile memory and does not have to be stored with CALibrate:SAVE.
If the password is set to 0, password protection is removed and the ability to enter the calibration mode is
unrestricted.
Command Syntax
Parameters
Examples
Related Commands

CALibrate:SAVE

This command saves any new calibration constants after a calibration procedure has been completed in
nonvolatile memory. If CALibrate:STATe OFF is programmed without a CALibrate:SAVE, the previous
calibration constants are restored..
Command Syntax
Parameters
Examples
Related Commands
CALibrate:DATA<NRf>
<external reading>
A (amperes)
Unit
CAL:DATA 3222.3 MA
CAL:STAT CAL:LEV
CALibrate:LEVel <point>
P1 | P2
CAL:LEV P2
CALibrate:PASScode<NRf>
<model number> (default)
CAL:PASS 6812
CAL:SAV
CALibrate:SAVE
None
CAL:SAVE
CAL:PASS CAL:STAT
CAL:DATA 5.000
CAL:PASS 6.1994
Language Dictionary - 4
45