Output:pon:state; Output:protection:clear; Output:protection:delay - Agilent Technologies 66312A Programming Manual

4 - Language Dictionary

OUTPut:PON:STATe

This command selects the power-on state of the dc source. This information is saved in non-volatile
memory. The following states can be selected:
Sets the power-on state to *RST. Refer to the *RST command as described in this chapter
RST
for more information.
Sets the power-on state to *RCL 0. Refer to the *RCL command as described in this
RCL0
chapter for more information.
Command Syntax
Parameters
Examples
Query Syntax
Returned Parameters
Related Commands

OUTPut:PROTection:CLEar

This command clears the latch that disables the output when an OverVoltage, OverCurrent,
OverTemperature, Remote Inhibit, or Fuse Status condition is detected. All conditions that generate the
fault must be removed before the latch can be cleared. The output is then restored to the state it was in
before the fault condition occurred.
Command Syntax
Parameters
Examples
Related Commands

OUTPut:PROTection:DELay

This command sets the time between the programming of an output change that produces a constant
current condition (CC) and the recording of that condition by the Operation Status Condition register. The
delay prevents the momentary changes in status that can occur during reprogramming from being
registered as events by the status subsystem. Since the constant current condition is used to trigger
overcurrent protection (OCP), this command also delays OCP. Overvoltage protection is not affected by
this comand.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands
56
OUTPut:PON:STATe <state>
RST | RCL0
OUTP:PON:STAT RST
OUTPut:PON:STATe?
<CRD>
*RST *RCL
OUTPut:PROTection:CLEar
None
OUTP:PROT:CLE
OUTP:PROT:DEL *RCL *SAV
OUTPut:PROTection:DELay <NRf+>
0 to 2,147,483.647
Unit seconds
0.08 (Normal)
OUTPUT:PROTECTION:DELAY 75E-1
OUTPut:PROTection:DELay?
<NR3>
OUTP:PROT:CLE *RCL *SAV