[Source:]Digital:data; [Source:]Digital:function - Agilent Technologies 66312A Programming Manual

[SOURce:]DIGital:DATA

This command sets and reads the dc source digital control port when that port is configured for Digital I/O
operation. The port has three signal pins and a digital ground pin. Pins 1 and 2 are output pins controlled
by bits 0 and 1. Pin 3 is controlled by bit 2, and can be programmed to serve either as an input or an
output. It normally serves as an output. Bit 2 must be programmed high to use pin 3 as an input. Pin 4 is
the digital ground. The query returns the last programmed value in bits 0 and 1 and the value read at pin 3
in bit 2.
Program
Value
0
1
2
3
4
5
6
7
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands

[SOURce:]DIGital:FUNCtion

This command configures the dc source digital control port. The configuration setting is saved in non-
volatile memory.
Configures the port for Remote Inhibit/Discrete Fault Interrupt operation
RIDFi
DIGio Configures the port for Digital input/output operation (see DIG:DATA)
Command Syntax
Parameters
Examples
Query Syntax
Returned Parameters
Related Commands
[SOURce:]VOLTage
This command sets the output voltage level of the dc source.
Command Syntax
Parameters
Default Suffix
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands
Bit Configuration
2 1 0 4
0 0 0 GND Output
0 0 1 GND Output
0 1 0 GND Output
0 1 1 GND Output
1 0 0 GND Intput
1 0 1 GND Intput
1 1 0 GND Intput
1 1 1 GND Intput
[SOURce]:DIGital:DATA[:VALue] <NRf>
0 to 7
0
DIG:DATA 7
[SOURce]:DIGital:DATA?
<NR1>
DIG:FUNC
[SOURce]:DIGital:FUNCtion <CRD>
RIDFi | DIGio
DIG:FUNC DIG
[SOURce]:DIGital:FUNC?
<CRD>
DIG:DATA
[SOURce]:VOLTage[:LEVel][:IMMediate][:AMPLitude]<NRf+>
see Table 4-3
V (volts)
0
VOLT 2 VOLTAGE:LEVEL 200 MV
[SOURce]:VOLTage[:LEVel][:IMMediate][:AMPLitude]?
<NR3>
VOLT:TRIG
Language Dictionary - 4
Pin Setting
3 2 1
Lo Lo
Lo Hi
Hi Lo
Hi Hi
Lo Lo
Lo Hi
Hi Lo
Hi Hi
59