A Cpu Power Module (System Board, Socket X); Asr Lockup Detected: Cause; Automatic Operating System Shutdown Initiated Due To Fan Failure; Automatic Operating System Shutdown Initiated Due To Overheat Condition - HP ProLiant BL620c - G7 Server Troubleshooting Manual

03/19/2002
12:54 PM
FAN INSERTED
Main System
Location:
System Board
Fan ID: 03
**END OF EVENT**
WARNING:
information in the server documentation before removing, replacing, reseating, or modifying
system components.
IMPORTANT:
apply to the server you are troubleshooting. Refer to the server documentation for information
on procedures, hardware options, software tools, and operating systems supported by the
server.
NOTE:
by the server.

A CPU Power Module (System Board, Socket X)...

...A CPU Power Module (Slot X, Socket Y) Failed
Event Type: Power module failure
Action: Replace the power module. In the case of an embedded power module, replace the system board.

ASR Lockup Detected: Cause

Event Type: System lockup
Action: Examine the IML
lockup. For more information, refer to the HP ROM-Based Setup Utility User Guide on the server
Documentation CD or the SmartStart Support and Documents website
(http://www.hp.com/support/smartstart/documentation).

Automatic operating system shutdown initiated due to fan failure

Event Type: Fan failure
Action: Replace the fan.
Automatic Operating System Shutdown Initiated Due to
Overheat Condition...
...Fatal Exception (Number X, Cause)
Event Type: Overheating condition
Action: Check fans. Also, be sure the server is properly ventilated and the room temperature is set within
the required range.
To avoid potential problems, ALWAYS read the warnings and cautionary
This guide provides information for multiple servers. Some information may not
The error messages in this section may be worded slightly different than as displayed
("Integrated Management Log" on page 76) to determine the cause of the
Error messages 158